tag:blogger.com,1999:blog-7312025.post112921795381607509..comments2023-09-20T07:51:11.213-05:00Comments on whimsy: Time to face the musicUnknownnoreply@blogger.comBlogger9125tag:blogger.com,1999:blog-7312025.post-1129746561814580352005-10-19T13:29:00.000-05:002005-10-19T13:29:00.000-05:00I use the sock as my swatch. I use the needle rec...I use the sock as my swatch. I use the needle recommended on the band and start the sock. Once I get 4 inches done on the sock, I check the gauge. If the sock is not right, I rip it out and start over with a different number of stitches. I have had good luck with an Ann Nordling pattern which uses the measurements of the foot. Maybe part of the problem is in the fit of your pattern? IfAnonymousnoreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129664215640389432005-10-18T14:36:00.000-05:002005-10-18T14:36:00.000-05:00I do swatch. Sometimes, I swatch on DPNs, sometim...I do swatch. Sometimes, I swatch on DPNs, sometimes on Magic Loop, depending on what I plan to use. Sometimes, if I'm bold, I just cast on once I get close to gauge. Like, if I wanted 8 sts/in and my swatch on size 2's gave me 7.5 sts/in, I would probably just cast on for the sock with size 1's, and rip if I was wrong. <BR/><BR/>I don't like making little tubes, because to lay a tube flat in order to get a wide enough piece to measure, I have to knt a big tube! Instead, I cast on using one dpn, and knit across. Then, I push the yarn to the other side of the DPN (like you would if making i-cord), and loosely hang the working yarn across the back, and knit another row. Keep repeating until the swatch is about 2 inches long. I end up with a swatch that is flat, but with lots of long strands running across the back. This does eat up a lot of yarn, but when I'm done swatching, I just rip and reuse the yarn. <BR/><BR/>So far, I've done pretty well with sizing.Daniellehttps://www.blogger.com/profile/07921157145669493432noreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129336701376437802005-10-14T19:38:00.000-05:002005-10-14T19:38:00.000-05:00Oh man - do I feel your pain! Same yarn, different...Oh man - do I feel your pain! Same yarn, different pattern - I ripped an entire sock b/c I didn't have gauge. Do I check now? Nope - just keep knitting, just keep knitting. I figure - it's fun so it's ok if I have to rip, right?Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129322212608030942005-10-14T15:36:00.000-05:002005-10-14T15:36:00.000-05:00Okay, you would ask. Not sure of the answer. I a...Okay, you would ask. Not sure of the answer. I admit to not doing gauge swatches on socks. I have one particular sock pattern that works most of the time - with sock weight yarn, but sometimes as I knit along with a different pattern, I notice that the sock is not the right size(usually too large) at which point, I usually rip it out and start over. If I don't mind switching sock recipients, than I just continue along and give it to my husband, daughter or mother depending on who it fits. ChelleAnonymousnoreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129321696859658732005-10-14T15:28:00.000-05:002005-10-14T15:28:00.000-05:00I knit tiny little tubes to measure gauge, especia...I knit tiny little tubes to measure gauge, especially if I haven't used the yarn before (my gauge is all over the place, so I can't just assume what needle I need). In fact, there is a picture of one of the tubes in my most recent blog post. I cast on 40 stitches, divided them over 4 needles (I love dpns, but feel free to use any technique you like for small diameter tubes) and knit for a while in stockinette (good easy band practice knitting.) Once I knit 20 or so rows, I measured my gauge (in this case, 9 spi and 13 rpi I think). I switched to the stranded pattern I wanted to use in the socks and knit for a while, then tried ribbing. <BR/><BR/>And since I was wandering the internet looking for basic sock patterns to plug that lovely gauge into, the rough formula for dimension is ankle circumference minus 10%.Sarahhttps://www.blogger.com/profile/11722283573175650966noreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129259306891816952005-10-13T22:08:00.000-05:002005-10-13T22:08:00.000-05:00I can really empathize because I've struggled with...I can really empathize because I've struggled with the same issues. No worthwhile suggestions, but I'll be watching your comments to learn something.<BR/>I like Carole's suggestion so far. :-)Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129253990993650502005-10-13T20:39:00.000-05:002005-10-13T20:39:00.000-05:00Sadly, the smallest part of my body is my ankles, ...Sadly, the smallest part of my body is my ankles, so what I do is about 1.5 inches before starting the heel flap, I switch to smaller needles, like one or two sizes smaller, then return to my regular size for the heel flap and the rest ofthe sock. Just making that small change totally corrected the fit of the socks...no ankle bag.<BR/><BR/>Hope this helps!<BR/><BR/>Blessings,<BR/>~SusieAnonymousnoreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129234930320916002005-10-13T15:22:00.000-05:002005-10-13T15:22:00.000-05:00I'm under the impression that there is a formula t...I'm under the impression that there is a formula to socks having to do with calculating the circumference of your ankle against your gauge, etc. However, with most patterns that are textured or fancy and not just plain, that wouldn't help you much...Lishttps://www.blogger.com/profile/13643465724457403832noreply@blogger.comtag:blogger.com,1999:blog-7312025.post-1129227733626475422005-10-13T13:22:00.000-05:002005-10-13T13:22:00.000-05:00I'm no help, I don't bother with gauge on socks. ...I'm no help, I don't bother with gauge on socks. If they're too small for me I give them to my daughter, if they're too big, I give them to my husband. ;-)Anonymousnoreply@blogger.com